Bàn Nhiệt Mk2B 12v 24a Cho Máy In 3d
0 Đánh Giá
0 Đã Bán
32
90.800 đ
Xem sản phẩm trên ShopeeQuốc tế
chủ nhật 23/05/2021 lúc 04:59 CH
☃☃Dear friends, {forstrehhuj} has opened! ! ! Warmly welcome all of you to come and patronize. I will bring you the best shopping experience with my most sincere service! ! !☃☃
Features
Brand new and high quality
Dimensions (Outer): 214mm x 214mm
Dimensions (Heat Bed): 200mm x 200mm
Laminate FR4 1.6±0.15mm
2 Layer, 35μm Copper
Power Input: 12V/24V DC
Copper Plated Holes
Come with resistor and LEDs soldered,basic soldering skills needed to solder the power wire
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources. It features a central mounting hole on the front side to allow for three point mounting. This is much easier for bed levelling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity.Additionally, the solder pads have been greatly increased in size,making it much easier and allowing for the use of 1206 surface mount components.But this does not remove the need to use proper strain relief.
Please note: ABS filament is not recommended.
Package list:
1x PCB Heatbed MK2B
Features
Brand new and high quality
Dimensions (Outer): 214mm x 214mm
Dimensions (Heat Bed): 200mm x 200mm
Laminate FR4 1.6±0.15mm
2 Layer, 35μm Copper
Power Input: 12V/24V DC
Copper Plated Holes
Come with resistor and LEDs soldered,basic soldering skills needed to solder the power wire
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources. It features a central mounting hole on the front side to allow for three point mounting. This is much easier for bed levelling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity.Additionally, the solder pads have been greatly increased in size,making it much easier and allowing for the use of 1206 surface mount components.But this does not remove the need to use proper strain relief.
Please note: ABS filament is not recommended.
Package list:
1x PCB Heatbed MK2B